Computer Case Rolling Base
If you are using your computer case on the floor and need to clean your space, this rolling base makes it much easier to move your computer case around. It is designed to fit computer cases with the ATX form factor; however, it can be modified to fit larger or smaller cases.
Drawn by Omid FarsaniFOUNDING MAKER
Approved by Make It Use ItPublished Sep 25, 2026
What the build takes
- Plywood×1$20
2'x4'x3/4"
3/4" or Thicker
Alt: MDF - Insert Nut×16$3
M4X12
Any material
Alt: M4x12 Insert Nut - Screw×16$5
M4x14 Hex Socket Button Head
Alt: Any - Swivel Plate Caster×4$20
2"
Rubber
- Drill Bit×1$5
5.5mm
Alt: 7/16" Drill Bit - Primer Sealer×1$42
Zinsser BIN Shellac-Based Ultimate Performance Primer Sealer, 946mL
You can use any other shellac-based primer for MDF.
- Paint×1$10
Interior Paint, 237ml or larger
- Paint Roller×2$5
Foam or lint-free microfiber
- Circular SawAny Any
Cordless or Corded
You can use a jigsaw, tracksaw, tablesaw, or circular saw.
- DrillAny Any
Cordless or corded
- Drill Bit Depth Stop CollarAny Any
6mm
To drill all the holes at the same depth
- Screwdriver
Use a hex key if the screw has a hex-drive head
- Paint Roller CageAny Any
4" or smaller
- Measuring TapeAny Any
- Marking ToolAny Any
Pencil
- Hex KeyAny Any
5.5mm
The build, step by step
Cut the board
For this project, I used a sheet of MDF leftover from an old TV table. The TV tabletop was a trapezoid. I was able to cut a 24"x11" rectangle out of it, which worked perfectly for my application. Make sure you measure your computer case first, and add some room on the sides and each end.
Since the casters are screwed into the board, I prefer to use a board that is 3/4" or thicker. The MDF was 1" thick, which was perfect. You can use a 1/2" thick board for this project, but some bending may be visible when you place an ATX computer case or larger on it. Make sure you use shorter insert nuts and screws if you end up using a thinner board.
Prime/Seal, Paint, Satin (optional)
Make sure you prime the board before painting it. You can also stain the board if you desire a more natural look. For the MDF board, I used the Zinsser BIN Shellac-Based Ultimate Performance Primer Sealer before applying the topcoat.
Mark the location of holes
🔒 Unlocks with the planDrill the holes
🔒 Unlocks with the planDrive the Insert Nuts
🔒 Unlocks with the planInstall the Casters
🔒 Unlocks with the planSafety & disclaimers
Take safety seriously. Wear PPE (Personal Protective Equipment) at all times when working on this project. Read all manufacturers' user manuals to familiarize yourself with your equipment. Wear safety glasses/goggles when using a circular saw.
What changed in v2
Renamed Plan
